Gadgetbridge

Table of Contents

This page has moved
Heartrate measurement on MiBand/Amazfit

Whole day HR measurement
Sleep HR measurement
Bluetooth Heart rate sensor sharing to another apps
Here is how you can see your HR in BLE Explorer

This page has moved

⚠ The wiki has been replaced by the new website - this page has been moved: https://gadgetbridge.org/basics/features/sports/#heart-rate

Heartrate measurement on MiBand/Amazfit

Whole day HR measurement

You can set an interval of minimal HR checking:

OFF
Every minute
Every 5 minutes
Every 10 minutes
Every 30 minutes
Once an hour

And the band will take measurements at least once in this interval. If an activity is detected, more frequent measurements are taken, capturing the entire activity in detail. So it is often sufficient to use the Once an hour interval and the band will capture all your active time, plus one sample per hour during idle time.

Sleep HR measurement

The Use heartrate sensor to improve sleep detection enables HR measurement when sleep was detected by the watch. Whole day measurement (as per above) must be enabled for this feature to work.

Some devices (probably all or most Huami bands like Mi Band 2, [[Mi Band 3]], Mi Band 4, Mi Band 5, Amazfit Bip and more) support acting as a BLE HR sensor. You can enable this feature in the Device specific settings: 3rd party realtime HR access. Do note, that some devices seem to have this actually ON all the time and it cannot be disabled (Amazfit Bip, Amazfit Cor2, AmazfitBipLite, MiBand2).

There is another settings, to actually make the device visible: Visible while connected, make sure this is also enabled, so the below mentioned apps can actually find the sensor over bluetooth.

Once enabled (Visible while connected and 3rd party realtime HR access) , Gadgetbridge doesn't even need to be running and the data is still available via Bluetooth LE. For the Heart rate data to be actually measured and sent you need to either run an Activity on the band/watch or be in the Heartrate/Status screen (few seconds value only), or have Whole day HR measurement enabled. Because the whole day measurement detects activity automatically, once you get moving, HR measurements are taken frequently.

Some example known apps to work with these data:

See full manual of Integrating Sports Tracking apps with Gadgetbridge Sports Activities/Workouts on how to set this up.

Here is how you can see your HR in BLE Explorer

Once the sharing is enabled and activity is started on the device (or status screen on Bip is used) live data is visible in BLE Explorer, in the Heartrate section, first line (the 00002a37... characteristics). You must enable the notify toggle. GB does not need to run nor be connected anymore, the sensor remains available but you must keep the activity running, for fresh data to be sent.