WLED supports the E1.31 (sACN) realtime light protocol.
As of WLED v0.10.0, Art-Net is alternatively supported. All information on this page applies for Art-Net as well. You will need to switch to Art-Net mode in Sync settings and reboot once.
- 170 LEDs (510 DMX channels) are supported per universe.
- You can use up to 9 adjacent universes which is a total of more than the maximum 1500 LEDs WLED can drive.
- For a fluent 25ms (40fps) or more framerate, it is recommended to use no more than 3 universes (510 LEDs).
- It is not recommended to try and have multiple E1.31 sources send to a single WLED controller at the same time. It will impact performance and there is no priority handling implemented. WLED is only meant to handle a single source at a time.
- Configure WLED to connect to a WiFi Network. It was observed that sending E1.31 from a computer to WLED when accessed as access point (WLED-AP) may not work, see forum post.
We highly recommend the LedFx project in combination with WLED! If you want to use more than 170 LEDs with LedFx, you need to go to additional settings and set "Universe Size" to 510 when adding the WLED device!
Select the mode you want to use in Sync settings.
Incoming E1.31 packets will be ignored.
1: Single RGB
All LEDs are set to the same color. 3 Channels: Red, Green, Blue
2: Single DRGB
All LEDs are set to the same color. 4 Channels: Master Dimmer, Red, Green, Blue
Not a realtime mode. Allows setting WLED effect properties over E1.31 with 11 or 13 channels.
|2||Effect mode ID|
|5||Effect palette ID|
|12||White Primary (channel optional)|
|13||White Secondary (channel optional)|
4: Multiple RGB
3 Channels per LED in sequence. LED 0 Red, LED 0 Green, LED 0 Blue, LED 1 Red, ... Default mode, equivalent to pre-0.9.1 E1.31. This is the mode you want to use for xLights and LedFx.
5: Multiple DRGB
Like Multiple RGB, but the first channel is a brightness control. Master Dimmer, LED 0 Red, LED 0 Green, ...