Update README.md
This commit is contained in:
parent
2b4d55f118
commit
a9e43a2895
|
@ -4,7 +4,7 @@ DIY remote controller for the Ikea Ansluta lights (the 2.4Ghz version)
|
|||
##Intro
|
||||
|
||||
The Ansluta (OMLOP) line of Ikea lamps only let u use one remote controller for each light.
|
||||
I wanted to use multiple remote's to control one string of lights.
|
||||
I wanted to use multiple remotes to control one string of lights.
|
||||
|
||||
Another caveat of the original remotes is that it can only cycle through the different brightness levels. It cycles though: 0% - 50% - 100% - 50% - 0% - ....
|
||||
I would like to turn it on to 50% brightness and turn it off without cycling to 100%.
|
||||
|
@ -13,7 +13,7 @@ I would like to turn it on to 50% brightness and turn it off without cycling to
|
|||
|
||||
This project is based around an [CC2500 2.4Ghz wireless controller](http://www.ti.com/lit/ds/swrs040c/swrs040c.pdf) and an Atmega328 (ex Arduino Nano).
|
||||
|
||||
The choise for the CC2500 was easy because the original Anluta Remote uses this IC, so it's definately possible to use this for controlling my lamp.
|
||||
The choice for the CC2500 was easy because the original Anluta Remote uses this IC, so it's definately possible to use this for controlling the lamp.
|
||||
|
||||
Some code is loosely based on:
|
||||
https://github.com/Zohan/ArduinoCC2500Demo
|
||||
|
@ -141,11 +141,11 @@ The IDLE mode isn't used because after we configure the module we immediately se
|
|||
The SPI settings (found by looking at the graph in the datasheet "Configuration Register Write and Read Operations") are:
|
||||
* SPI Mode 0
|
||||
* MSB First
|
||||
* Max speed: 6Mhz (no need to use extra delays).
|
||||
* Max speed: 6Mhz (no need to use extra delays)
|
||||
|
||||
The prototype code simply sends the necessary signals to turn the lights on and off in an endless loop (for testing purposes).
|
||||
Now that the prototype works it's time to make a couple of remotes to control the light.
|
||||
|
||||
It's needed to remark that the givven code uses the addres that my original Ikea remote has. Somewhere within the 8 bytes that are sent in a burst will be an unique identifier. Without another remote to compare it to I don't know what the identifier is. (Probably there will also be a sort of error detection like CRC).
|
||||
It's needed to remark that the givven code uses the address that my original Ikea remote has. Somewhere within the 8 bytes that are sent in a burst will be an unique identifier. Without another remote to compare it to I don't know what the identifier is. (Probably there will also be a sort of error detection like CRC).
|
||||
|
||||
##Designing a PCB
|
||||
|
|
Loading…
Reference in New Issue